Crimping process of automatic terminal crimping machine

The bending of the barbs and barbs of the automatic terminal machine is not necessarily a positive crimping process, but the connector will also fail. The barb may be bent excessively inward or outward, and this affects the ability of the terminal to completely sink into the plastic housing. The barb facing damage may be caused by the terminal being clamped too tightly on the shaft of the friction wheel of the crimping machine from the reel, and it may also cause the cable to be removed after crimping during startup.

Fully automatic terminal machines usually terminate the cables to be bundled, stocked or shipped to another location in the factory. Bundled sales, or each end of the cable from the wire harness can be bent and barbed. If it is damaged in the fully automatic terminal crimping machine, then you need to adjust the tightness of the friction wheel and simply keep the terminal reel not expanding due to its weight. If the problem is in the binding process, use a smaller harness or improve the processing procedure.

How should the automatic terminal crimping machine dehumidify?

Dehumidification is a very important lesson in the maintenance of the automatic terminal crimping machine. Once the automatic terminal machine is damp, it is extremely easy to affect its performance. How can we effectively and safely dehumidify the automatic terminal machine? The following is the summary of the terminal machine manufacturer Some methods that came out:

1、Use air conditioning to dehumidify. Most air conditioners now have this function. Starting the dehumidification function of the air conditioner can effectively solve the problem of humidity in the room during rainy and rainy periods, and can also form an all-round protection for the automatic terminal machine.

2、When the factory's automatic terminal machine is not in use, it is best to make a protective cover, which can effectively prevent the back of the electrical appliance from contacting humid air. At the same time, you can also increase the frequency of using these appliances, because the machine generates heat when it is running, which can effectively dissipate moisture. If the computer cannot display due to humidity, you can turn it on and power it on, and the display can work again in about 10 minutes.

3、If the outside air is too humid, remember to close the doors and windows; if the room is too humid, ensure that the room is ventilated. You can use air conditioners and fans to dehumidify.

4、If there is "sweat" on the wall, it is recommended to buy a dehumidifier to dehumidify. It is best to use an industrial dehumidifier.

5、In long-term humid areas, you can use charcoal in the room or spread bamboo charcoal under the indoor floor, which has a good effect on the balance of room humidity and the prevention of dust and air purification. Generally, it is best to cover the floor with cartons.

6、Put some quicklime (mixed with sand) in the wet corners.